Yoke photometer ZPM-RGB (red-green-blue)

The yoke photometers ZPM-RGB measure the transmission of plane, optical transparent materials like quartz, glass, crystal or plastics plates. The newly available version RGB measures the transmission for red, green and blue wavelengths. With this, impurities or components with different spectral properties can be detected, and evaluations of colour are also possible.>

UV-LED Spot Lamps and UV-LED Irradiation Systems

We use high power UV-LED in our new point sources and irradiation systems. We develop and manufacture customized lamps and irradiation systems for your application.

Advantages: long lifetime, low power consumption, low heat, compact devices, direct irradiation without light-guide, fast switching on and off possible.

Applications: UV gluing, UV curing, UV marking, UV drying of printing inks and lacquers, fluorescence excitation, …

Irradiation chamber BS-09

Highlights:

• 2kW medium-pressure burner
• stabilized UV intensity
• irradiation area: 60 x 40 cm
• irradiation height: 30 - 90 cm
• tool free lamp change is done within a few minutes
• holder for filter plate
• cooling of the filter plate

PLC sensors

The PLC sensors serves for the measurement of irradiances with system controllers. Sensors with different spectral range, supply voltage and output signal can be supplied according to customers demands.

Irradiation chamber BS-05

Irradiation chamber with UV tubes above and beneath the sample. Simultaneous irradiation on two sides possible. Rotating sample holder made of quarz.

Yoke photometer ZPM-950

The yoke photometer ZPM-950 serves for precis measurement of transmission of quarz, glass and plastic plates at 950nm. Data transfer to PC avaible. Custom wavelengths are avaible.

UV-irradiation chamber BS-08

Equipment for the intense irradiation of small parts. Parts are loaded for the irradiation with a drawer. Lower lamp power during stand-by mode to increase lamp lifetime.

Irradiation hood BS-07

Controlled exposure of circuit boards

Integrating sphere with 2.5m diameter

We supplied an integrating sphere with a diameter of 2.5 m to the Federal Standards Laboratory (PTB / Physikalisch-Technische Bundesanstalt) in Braunschweig.

Here you may take part in the installation process.

High Intensity UV spot Source HP-120

120W-light source for quick spot curing within seconds including one light guide